Safety related matters of waste stripping machine
12/27/2024Safety related matters of waste cleaning machine
4.Safety related matters of waste cleaning machine HS-2836: 1. Press the switch to start, and the chain starts to rotate;
2. When the speed stabilizes, the waste stripping machine is flat or the tail is slightly higher, put the head close to the waste edge, and gently put it on the half of the waste edge to start discharging waste.
3. The wire is 4 meters long. If it is not long enough, you can connect it to a plug board. The wire should not be dragged on the floor. pneumatic waste stripper is recommended to hang it in the air to avoid being pressed and dragged by waste paper.
4. It is recommended to wear a mask, goggles, gloves and work healthily when cleaning waste.
5. After working for about an hour, drip a few drops of lubricating oil on the chain to cool it down, and the machine will rest for more than ten minutes.
6. After get off work, unplug the wires, clean and store them properly, and do not block the left and right heat dissipation vents of the motor.